Support Articles

 

 

Article

How do I add a Savant Remote or Savant Lamp Control after my Savant Home has been set up?

« Go Back

Article Information

 
TitleHow do I add a Savant Remote or Savant Lamp Control after my Savant Home has been set up?
Full Description
Caution
Use a Savant Lamp Control only for lamps. Do not attempt to control any other type of device with a Savant Lamp Control.
 
NOTE:You can add up to four Savant Remotes to a Savant Host ; one per room.

To add a Savant Remote or a Savant Lamp Controller, do the following:

  1. Unpack the Savant device and plug it in.
    The LED status light on a Savant Remote Base or Lamp Controller will blink yellow to indicate its readiness to connect.
    NOTE:It takes about 8 seconds for a Lamp Controller to fully power on.
  2. The Savant App automatically scans your home for Savant devices and displays a notification on the Home View that it has detected a new device. Tap this notification to add the device.
  3. Add the device by following the steps below.
    • If the Savant App has found a single device, tap Select Room under the picture of the device.
    • If the Savant App has found multiple devices, such as three Lamp Controllers, it displays a picture of each one. To select one of these devices for adding, tap Locate under its picture. Tapping Locate makes the LED status light on the device blink quickly, enabling you to identify which device you are adding.
      • The LED on a Savant Remote is located on the bottom of the Base.
      • The LED on a Savant Lamp Controller is located on one of the device’s triangular sides that is opposite the plug.
      • When the LED on the device you want to add is blinking red, tap Select Room under the picture of the device.
    A menu appears, listing familiar room types, such as Bedroom, Bathroom, Kitchen, and Office. The menu also includes Other, which enables you to type your own name for the room.
  4. Add the device to a room.
    • Tap the name of the room where the device is located.
    • If you selected Other, a keyboard appears. Type the name of the room. Tap Done.
    Once you have tapped Done, the Savant App displays a message saying it is connecting to the device. When it has finished connecting, your Savant App reports that the device has been added.
  5. The Savant App asks if you have added all your Savant devices. If you have, tap Yes. If you have not, tap No and repeat these steps until you have added all your Savant devices.
URL NameHow-do-I-add-a-Savant-Remote-or-Savant-Lamp-Controller-after-my-Savant-Home-has-been-set-up